Erfurt MAV

01427 616597

Wallrock Power Adhesive

Wallrock Thermal Liner Adhesive

Wallrock Brochure DownloadHigh performance extra strength ready-to-use wallcovering adhesive powered by Wallrock

Wallrock Power Adhesive is suitable for hanging all types of wallpapers - no mixing is required. The smooth, easy to use adhesive has excellent wet tack properties and slides easily for perfect hanging and pattern matching whether you choose to Paste-The-Wall** or paste the paper wallcoverings.

** Paste-The-Wall wallpapers are specifically designed and should be identified upon commencement.

  • Suitable for most types of wallpaper
  • High performance aqueous paste based on a blend of natural starches
  • Thick, smooth, easy to use formula - roll or brush straight from tub
  • Low splatter, high wet tack, easy to slide and position
  • Added PVA for increased strength, resistance to moisture and humidity
  • Contains an inhibitor to prevent mould, yeast and fungal grow

Can be used to hang

  • Wallrock Products*,
  • Anaglypta Products*,
  • Standard Wallpapers,
  • Embossed Wallpapers,
  • Paste-The-Wall Wallpapers,
  • Expanded,
  • Heavy-Weight & Luxury Vinyls and Fabric & Glassfibre Wallcoverings.
  • *not recommended for Wallrock Thermal Liners, Insulators Range, Cosy Liner KV300 or Sound Insulation where Wallrock Thermal Liner Adhesive should be used.

Surface Preparation

  • Surfaces should be clean, dry, sound and free from loose paint, plaster, dust and mould.
  • Drywall and other absorbent surfaces must be sized and completely left to dry.
  • Sizing should be completed at least 4 hours before. Pasting And Hanging - Paste-The-Wall
  • Refer to wallpaper manufacturers label for specific instructions. Ensure wallpaper is suitable for Paste-The-Wall application.
  • For best result use a roller to apply Wallrock Power Adhesive generously and evenly to the wall. Ensure coverage of the wall from floor to ceiling is complete.
  • A coverage rate of 1Kg per 5m2 (2.2lb per 53ft2) is suitable for most products.
  • Paste up to two widths of wallpaper at once to reduce decoration time.
  • Apply paper to pasted wall.
  • Simply position wallpaper sheet by sliding and smooth into final place under pressure using a squeegee, wallpaper brush or damp sponge.
  • Complete hanging and trimming as normal.

Pasting And Hanging - Paste-The-Paper

  • Refer to wallpaper manufacturers label for specific instructions - eg. soak time etc.
  • Protect surrounding areas (floor coverings and furniture etc) from splashes and drips.
  • Paste wallpaper generously, ensuring that edges are fully covered with the paste, allow heavyweight papers to soak until supple, (unless Paste-The-Wall products ie. Wallrock).
  • A coverage rate of 1Kg per 5m2 (2.2lb per 53ft2) is suitable for most products.
  • Ensure edges are stuck to the wall.
  • Remove any paste from the face of the wallpaper and surrounding area immediately with a damp cloth or sponge.
  • Clean tools and equipment in warm soapy water.


  • Do not thin or add water to the adhesive.
  • Not suitable for hanging borders or overlapping seams on vinyl wallpapers.
  • For best results use vinyl to vinyl adhesive for hanging borders, overlapping seams, and for repairs.
  • Contains fungicide and biocide to inhibit mould, yeast and bacteria. Keep away from children and animals. Wash hands thoroughly after use.
  • Do not empty into drains or watercourses. Waste should be disposed of using authorised disposal routes and sites.

This is a simple wallpaper calculator and should be used as a guide only. You can find the roll width and roll length you are after on the specific product page.
Roll widths are provided in meters (such as 0.5 x 10mtr) so your wall widths and heights should be inputted in meters also.
If you are purchasing an offset match product then you may need a little extra as there may be some waste. If you have any windows or doors in your walls you can simply ignore these. This will give a good estimate of required roll numbers.

Wallpaper Calculator