01427 616597enquiries@erfurtmav.com
In order to keep up with the ever increasing technical demands for our products, we have developed Wallrock Thermal FR Adhesive - an extra strong adhesive with added flame retardant properties, to help protect combustible surfaces.
The Adhesive has been designed to create a permanent bond for our technical linings, and also incorporates active fire retardants that assist with the dampening of flames and help to enhance the fire performance of the product it is used to hang, such as Wallrock Fireliner and Insulating Lining Paper Graphite Plus. Both of these popular products have been used in conjunction with Wallrock Thermal FR Adhesive as part of a system which have been tested to BS476, the test results can be seen by clicking the links below. It also delays the onset of further combustion.
The incorporated flame retardant additives are integrated into two separate mechanisms, each having a synergistic effect on the other. The first endothermically removes heat from the reaction and the second creates a thermal insulation barrier between the burning and the unburnt components on the wall - this is achieved by creating a protective char, which in turn slows down heat transfer to the unburnt fuel.
Wallrock Thermal FR Adhesive used with Wallrock Fireliner
Wallrock Thermal FR Adhesive used with Insulating Lining Paper Graphite+ and Wallrock Fireliner
Wallrock Thermal FR Adhesive can also be used to hang other products, where an enhanced fire protection is preferred.
Typical consumption on Wallrock Fireliner is 0.5kg per square metre.
Wallrock Thermal FR Adhesive has had hours of time in research and development to ensure we have the best mix of ingredients - therefore giving the best possible performance.
Please note that the type and condition of the surface being covered as well as the surface finish applied will effect fire performance.
High perfomance aqueous adhesive with fillers and added fire retardants
Thick, smooth, low splatter formula - roll or brush straight from the tub
High 'wet-tack' to hold in place while cutting and positioning
High resin content for optimum adhesion to surfaces
Contains an inhibitor to prevent mould, yeast and fungal growth
Available in 5kg tubs
This is a simple wallpaper calculator and should be used as a guide only. You can find the roll width and roll length you are after on the specific product page.Roll widths are provided in meters (such as 0.5 x 10mtr) so your wall widths and heights should be inputted in meters also.If you are purchasing an offset match product then you may need a little extra as there may be some waste. If you have any windows or doors in your walls you can simply ignore these. This will give a good estimate of required roll numbers.
