A standard adhesive product containing flakes of dry adhesive.
Can be mixed at different strengths to hang most wallcoverings from lining paper to vinyls and heavy embossed wallpapers.
Mixes in two minutes, creates a storng bond and has excellent slip for perfect pattern matching.
Contains a fungicide to inhibit mould growth.
Fast mix formula, available in 10 roll sachets.
Mixing Ratios / Approximate Coverage• Normal wallpapers (including woodchip) – 7L per sachet – 8-10 rolls• Vinyl wallcoverings and washables – 5.5L per sachet – 6-8 rolls• Textured and blown vinyls – 4.5L per sachet – 3-5 rolls• Paste-the-wall wall coverings – 4.5L per sachet – 2-4 rolls • Embossed papers – 4.5L per sachet – 2-4 rolls• Heavy embossed papers – 4.5L per sachet – 2-4 rolls• For use as a size – 9L per sachet – 100m²
Always follow the manufacturers instructions when hanging wall paper. Remove and old wallpaper from the wall or ceiling and ensure the base surface is clean, dry and slightly absorbent.
Surfaces may need to be sized, especially absorbent surfaces such as new plaster.
Always prepare surfaces with lining paper for the best results, especially important when plaster has visible defects such as cracks or damage.
Measure out the correct volume of water into a bucket (see chart for guidance) and sprinkle sachet contents into the water whilst stirring briskly for 20 seconds. Allow to stand for 2 minutes.
This is a simple wallpaper calculator and should be used as a guide only. You can find the roll width and roll length you are after on the specific product page.Roll widths are provided in meters (such as 0.5 x 10mtr) so your wall widths and heights should be inputted in meters also.If you are purchasing an offset match product then you may need a little extra as there may be some waste. If you have any windows or doors in your walls you can simply ignore these. This will give a good estimate of required roll numbers.